gym dumbbell stand

a support that will help you avoid the annoying gym dumbbell in your legs when you do bench press.All components must be printed in PETG or ABS with support throughout. The 30% infill is sufficient on all parts except the "clip" which I recommend at 55%. Layer height 0.2mm, shell thickness 1.2mm, bottom/top thickness 1.2mm except the "clip" part which should be 2.4mm. For the 2mm diameter axle hole I used a nail drilled to the desired length and for the 3mm hole I cut two pieces of M3 threaded rod approximately 34mm long.