Gyroid Infill Shelf Brackets

Set the top and bottom layers to 0 to reveal the infill pattern I used 8% infill, at 8% infill the part is reasonably strong but I wanted a nicely defined infill. 15-20% would be better for strength but would make the pattern less noticeable.

I created this to use as gussets for an over-monitor shelf to fasten to my desk. They could be scaled up or down for a number of uses.

There is a .3 countersunk standoff inside so that 1" screws can be used on 3/4 thick wood without screws protruding.

CURA SETTINGS

Print Quality - Standard Quality
Layer height - .2mm

Wall Thickness - .8
Wall Line Count - 5
Horizontal Expansion - 0

Top Thickness - .8
Top Layers - 0
Bottom Thickness - .5
Bottom Layers - 0

Infill Density - 7.5
Infill Pattern - Gyroid

Print Temp - 200
Build Plate Temp - 60

Print Speed - 120mm/s

Enable Retraction - Yes
Z Hop When Retracted - Yes

Generate Support - no
Support Placement - Everywhere
Support Overhang Angle - 45

Build