H2D Poop Chute Adapter

This is an adapter for the H2D poop chute designed to work with a 4-inch diameter dryer air duct. The adapter uses two BT3×20 screws from Bambu Lab.Installation InstructionsRemove the screw located directly underneath the poop chute.Partially install a BT3×20 screw into that lower hole.Remove the screw at the top of the chute.Slide the adapter into place, guiding the notch over the partially installed lower screw. This helps hold the adapter in position.Align the top hole of the adapter with the chute and reinstall the top screw through the adapter.Tighten both screws until snug. Do not overtighten, as this may crack the adapter or strip the threads in the H2D.Once the adapter is secure, attach the dryer duct and fasten it using a worm-gear clamp.