H2D Purge Basket

After receiving my H2D I realized that I needed a Poop Chute, so I designed this model that is similar to the one that I use on my P1S. It fits neatly around the corner of the H2D and tightly against its side. It can be printed without supports on an H2D printer. I manually put a brim on the standoff foot, which can be cut off it desired. A 40x10x3 magnet should be used to help it stick to the back of the printer. The chute sits on the table next to the printer, without the magnet, the rocking of the printer (which is on soft feet) will push the chute away from the printer, creating a gap between the printer purge chute and the poop chute. This can cause problems, with either: 1) poops falling on the table, negating the value of the chute, 2) or worse, poops get stuck in the gap. Stuck poops will back them up into the printer, eventually causing a print error! The magnet is strong enough to keep the chute against the back of the printer, even when it is rocking.It takes about 520g of f