MakerWorld
3D Printer Accessories
Model downloaden
H2D Slim Purge Bin
378
Downloads
58
Likes
209
Makes
This purge bin is designed to fit when you don't have much room behind your printer. It's perfect if you have roughly 60cm / 24inch room for your printer in total (front to back). It protrudes 60mm from the back of the printer. It can be easily removed with one hand and slides easily back into its rails. Installation is very simple. You simply screw on the bracket using the existing screws on the back of the printer. Do not over-tighten the screws. You can easily remove the built-in suports by hand. The multicolor versions are designed to produce very little waste when printed on the H2D.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
