H2D Under-printer plate holder

DISCLAIMER!I am not responsible for any injuries you may sustain if you do not take proper precautions when installing the blocks. The printer is heavy! You should have two people to lift it.I am also not responsible for any damage to your printer. Make sure it is stable on the blocks. Ensure that the blocks only touch the edges of the printer; the center should remain clear. There are exposed mechanisms and belts underneath the printer. Be careful not to place these mechanisms directly on the blocks.And finally, make sure the printer is stable. I recommend starting a calibration and monitoring it. The printer should not show any instability. If it does, make sure the printer’s feet are properly seated in the cavities of the support blocks. Also, monitor the first prints to ensure everything is fine. July 2025, Version 1.1The cutting plate is more difficult to insert into the slots due to the adhesive protectors placed on each side. Additionally, since the slot for this plate was place