H2S Buffer Clicking & AMS Overload Temporary Fix

Last week I got my H2S and it has been wonderful! However, when I am printing large parts where the print head travels to the front portions of the print bed the filament PTFE tube pulls too much on the buffer causing it to bind due to being slightly too short. This both creates and audible noise and caused an AMS overload error. I designed a pretty basic little bracket that doesn't allow the tube to pull the buffer in a way that causes it to bind. I consider this as a temporary fix as a longer PTFE tube is the proper solution, but this has been working well enough for the time being. I installed it about half an inch from the buffer outlet using double sided tape. Make sure to use double sided tape on the whole backside face of the bracket or else it will be pulled off by the PTFE tube.