Thingiverse
Hab Block Container
von grognarl
43
Downloads
26
Likes
0
Makes
Wanted to create some container homes similar to those made Brutal Cities, but wanted a FDM option.
There are spaces above and below for magnets to fit, so that you can stack your buildings, one on top of the other. The holes require a small amount of filing to fit the magnets in snuggly. Magnets used were 3x3x5 mm.
v2 editions- changed the length of the ridges at the top and bottom of either side. Printers that bridge well will not need supports.
v2 Hollow editions- created hollowed out variations of the models.
There are spaces above and below for magnets to fit, so that you can stack your buildings, one on top of the other. The holes require a small amount of filing to fit the magnets in snuggly. Magnets used were 3x3x5 mm.
v2 editions- changed the length of the ridges at the top and bottom of either side. Printers that bridge well will not need supports.
v2 Hollow editions- created hollowed out variations of the models.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
