Thingiverse
HACK'IT PUSH PIN 32MM
1
Downloads
2
Likes
0
Makes
Brief:
Designed to use in tandem with the HACK'IT furniture research project, a plywood 32MM push pin is used as a fixture.
Printing:
During this print, no raft was required, ran with a PLA standard-setting taking approximately 40 Mins per pin.
Full print with 15% infill came to about 6g in weight.
Minimal to no post-process required depending on printer settings and maintenance.
Designed to use in tandem with the HACK'IT furniture research project, a plywood 32MM push pin is used as a fixture.
Printing:
During this print, no raft was required, ran with a PLA standard-setting taking approximately 40 Mins per pin.
Full print with 15% infill came to about 6g in weight.
Minimal to no post-process required depending on printer settings and maintenance.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
