Thingiverse
HackerBoxes #0044 Simon Badge Case
von ddb2ness
2
Downloads
1
Likes
0
Makes
This is a case for the HackerBoxes #0044 SIMON SAYS Badge Kit. The badge slips into the case to protect fingers from the pokey leads on the back.
Prints well at 0.2mm layer height and doesn't need much infill or any supports.
The clips should hold the unit in place but feel free to secure with a few screws though the holes in the corner.
Prints well at 0.2mm layer height and doesn't need much infill or any supports.
The clips should hold the unit in place but feel free to secure with a few screws though the holes in the corner.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
