Thingiverse
HadronZnutHolder
von GearNut
17
Downloads
4
Likes
0
Makes
I didn't like the stainless steel blocks on my Ord BOT Hardon,
because stainless on stainless has a tendency to gall.
Sized for a 5/16-18 nut. I tapped 5/16 nuts to 8x1.25mm.
No Z wobble isolation. Don't know if it is needed?
because stainless on stainless has a tendency to gall.
Sized for a 5/16-18 nut. I tapped 5/16 nuts to 8x1.25mm.
No Z wobble isolation. Don't know if it is needed?
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
