Haenau - Belts

This is the arraignment of the belts,
Unfortunately, it still does not look too clear,
But I promise you, it dose work extremely well.

excuse the OpenSCAD model,

but just trying to get arrangement correct.

Note, actually feeding the belts through will probably take more than 2 goes to get it right.


first, using at least 2 pegs, on the silver rod, to stop dolly sliding back & fourth.
And BOTH motors pushed as far towards the back as sensible,
without obstructing the screw heads.

then ..
I recommend, loosely fitting the back left port on the dolly,
making sure that the teeth are facing away from you.
next through the slider, over the top pulley, towards you,
around left motor pulley.
all the way to the back left pulley, through the slider (yes at a strange angle)

around the back right,
into the slider, and tie off on the front upper corner of the dolly.

do not attempt to tighten the belt yet.

fit the second belt,

and gradually balance the tension,