Haenau - Update

A few minor changes, to the front motor mounts.
and a re-design for the back mounts.

Also a NEW E3D - easy swap print head dolly,
and an untested 'DIAMOND HEAD' mount,
> still waiting for MK8 extruders from china, so cannot test it :(

Videos:
First print, Marvin - https://youtu.be/JAmZMetpKMQ
Some SERIOUS Z-Wobble: https://youtu.be/t6d9e5BzREk

Note: Z Wobble was because the threaded rod was not correctly fitted in the coupling !

Myself and my 10 year old daughter built this printer, so she can have her own printer.
with only a couple of screwdrivers, drill, small PCB (used as a spacer - so brackets were in same height) good ruler, I did use a set square, but it relay is not needed.
and a jig-saw, to cut out top sheet.
And the panels, were cupboard doors/shelves, so no need for table saw, because accuracy is already there.

I think there is going to be a lot of Mine-craft prints in the house soon.

If you can afford a REAL E3D Hotend, then I do recommend it,
J