MakerWorld
Hueforge & Lithophane
Voir le modèle
Hagrid
6
Téléchargements
25
Likes
4
Makes
You can check out my other Harry Potter prints →here← Project: HagridPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mm This print uses 6 OR 7 unique filamentsPLA BambuLab Basic Black PLA BambuLab Basic Blue Gray PLA BambuLab Basic Brown PLA BambuLab Matte Nardo Gray (OR you can use Dark Gray or Blue Gray again). Nardo actually helps keep his skin tone LIGHTER. PLA BambuLab Matte Orange Mandarin PLA BambuLab Matte Dark GreenPLA BambuLab Matte Ivory White Swap Instructions:Start with BlackAt 0.72mm swap to Blue GrayAt 0.88mm swap to BrownAt 1.2mm swap to Nardo Gray (or Dark Gray or Blue Gray again)At 1.36mm swap to Orange MandarinAt 1.44mm swap to Dark GreenAt 1.6mm swap to Blue Gray At 1.84mm swap to Ivory White for the rest.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
