Thingiverse

Hairspray Pump

di derailed3d

769 Download

593 Likes

4 Makes

Vai al Modello

*Please read the safety concern section below*

Most of you have glass beds, and hairspray is one of the most commonly used bed adherence tools.

I'm not a fan of removing my glass bed every time I re-apply hairspray so I usually fold a paper towel into a little square, and spray the hairspray onto there, and then wipe it on in a thin layer in the middle of the bed. This has worked great, except I need two hands to do this, and I always end up coating the other hand in hairspray.

I was modeled after a can of unscented extra super hold Aquanet, but this has fit with a wide range of compression cans.

*********NOTE*********
*********If It doesn't mist out and it ends up streaming out, (the hole may seal due to over extrusion), just take a thin needle or pin and tap it into the hole. I used a 0.5mm needle to enlarge my hole, mists perfectly now*********

1) Print this out
2) Pull off the spray nozzle on your bottle of hairspray
3) Snap this into place
4) ...
5) You're d

3dlac Adhere adhesion aquanet bed bottle can cap convenient easy glass Glass bed hairspray Paper towel press Press pump pump rag snap spray spritz Squirt stick top 3dlac Adhere adhesion aquanet bed bottle can cap convenient easy glass Glass bed hairspray Paper towel press Press pump pump rag snap spray

Fonte

Thingiverse

Cosa serve per stampare: Principiante Bassa affidabilità

Pezzo unico

Supporti 1/3

Assemblaggio 0/3

Impostazioni 1/3

Dimensioni piano 0/3

Post-lavorazione 0/3

Stampante

FDM / FFF

Formato file