Half a Pine cone (Photogrammetry)

Scanned an pinecone I've picked up from a garden in France.

Sliced into half for easy printing on the base. Can be use to stick on walls for Decor if necessary. Creativity is up to you guys!

The model itself is rather small, size it up to 300-400% for a real-life size

This model has 100,000+ Mesh Faces, recommended to slow your printer speed to get the most detail out of it (perhaps 40mm-60mm/s for infills and perimeters)

Go high layer resolution on this one. 0.1mm Layer height will do the trick!