Thingiverse
Fashion
Go to Model
Half-face Mask
206
Downloads
208
Likes
0
Makes
based on an asian girl’s face，with smooth appearance.
I suggest you printing it with PLA filament.
If the mask is too wide than yours，you can dip it into hot water(80℃~85℃) ,which is able to soften PLA Material, for a few seconds, then put it on your face and push it towards your face, then you can get a much fitter mask.
Thank you for your printing, I'm looking forward to your Makes!
I suggest you printing it with PLA filament.
If the mask is too wide than yours，you can dip it into hot water(80℃~85℃) ,which is able to soften PLA Material, for a few seconds, then put it on your face and push it towards your face, then you can get a much fitter mask.
Thank you for your printing, I'm looking forward to your Makes!
ohayooo also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
