Hall sensor Ender 5

This is the Z Hall endstop for Ender 5, or other. It's made for 2020 profile, and to rotate the plug on 90 degree.
For reference see the pic.
There are 2 M3 holes inside the case to screw the board, but it is actually not needed.
All components should be soldered from the traces side, except for 3 pin connector.

Switch time from 0V to 5V - 1.52 microseconds
Rise time 725 nanoseconds (see pics)

If the total thickness of the bed is about 6mm - no adjustment needed.
You will need 5*2mm magnet 1pcs, and to make a M4 thread with the tap.

Printed with HIPS.
Be carefull, only one side of the magnet turns the switch.
Due to its long range of sensitivity (~5-6mm), some changes in Marlin is required:
Configuration_adv.h
#define Z_HOME_BUMP_MM 0
It will home once, or

#define Z_HOME_BUMP_MM 6
for twice homing, as usual


I recommend LJ12A3-4-Z/BX inductive sensor.
https://www.thingiverse.com/thing:3725057