Halloween Candelabrum

This is a mixture of multiple objects found in 3 Thingiverse. Printed everything without any support. The pumpkin will need a brim to hold it on the printer. I used 8mm brim. After printing you can assemble. Once everything fitted I used acetone to glue it all together.

This is my first "creation". There may be some unknown issues. Let me know in the comment and I'll do my best to answer. I'm a beginner so I'm still learning a lot.

Cups: printed it upside down to get a glass look on the top surface. CR-10 was able to handle the base of the candle without any support. If using a different printer this might be one where you will want to use a support.

Arm: Printed a mirror image so left and right side had the same surface texture. One side will have the smooth glass finish. I did turn on support just for the tabs. There was a little bit of sanding to get it into the slot but it works and stays pretty tight in there. If it doesn't use a little acetone and stick it in.

Cent