Halloween Headstone Stakes

This is a simple functional design I came up with to solve the problem of my Halloween grave stone decorations getting blown over in the wind due to the inadequate stakes they come with. These stakes were modeled after the ones that came with my decorations, but are about 4 times their size, ensuring more ‘bite’ into the ground to hold the decorations in place. PRINT WITH 100% INFILL FOR MAXIMUM STRENGTH. Please take special care to make sure the spikes are centered front-to-back in your decoration when inserting them to make sure they don't poke through the front/back if they are relatively thin decorations. I recommend installing them into the headstone first, then removing them to pre-puncture where they need to go. Then take them our of the headstone and push them into the ground and return the headstone to it after. Also note that since these are longer, you will most likely need to ‘work’ the spikes into the ground a little at a time, to prevent over bending and stressing the