Thingiverse
Halloween Jack-o'-Lantern
door fishlet
696
Downloads
508
Likes
0
Makes
Customizable 3D Printed Jack-o'-Lantern
This ornament designed in OpenSCAD prints in three pieces: bottom, top, and stem. Tabs on the bottom and top ensure proper alignment, while the stem is super-glued to the top.
Pre-rendered STL files are included for two suggested sizes: small (100 mm = 4" diameter) and large (120 mm = 4.75" diameter).
Of course, this is ideally printed in orange with a brown stem. Support material is required for printing the top and bottom due to the spherical shape, as well as the carved holes.
This ornament designed in OpenSCAD prints in three pieces: bottom, top, and stem. Tabs on the bottom and top ensure proper alignment, while the stem is super-glued to the top.
Pre-rendered STL files are included for two suggested sizes: small (100 mm = 4" diameter) and large (120 mm = 4.75" diameter).
Of course, this is ideally printed in orange with a brown stem. Support material is required for printing the top and bottom due to the spherical shape, as well as the carved holes.
fishlet publiceert ook op
8 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
