Thingiverse
halloween jackolantern
von Craftcentric
0
Downloads
1
Likes
0
Makes
Hardcore solid works creativity here i tried my best without getting into blender try using the halves if its hard to print but I printed the whole thing from the bottom it will turn out okay with a bit of supports
I use a 65 degree overhang nothing to extreme but could use maybe a 55 degree
200 or 195 degree on my PLA OF CHOICE - polymaker polyterra
excuse the sound on the video playing with the shorts feaure lolling my ass off
I use a 65 degree overhang nothing to extreme but could use maybe a 55 degree
200 or 195 degree on my PLA OF CHOICE - polymaker polyterra
excuse the sound on the video playing with the shorts feaure lolling my ass off
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
