Halloween Lantern

Halloween Lantern based on Workshop Companion's lantern (though not done by his plans).
https://www.youtube.com/watch?v=wr8KVBQxFsM (unaffiliated)

I included four panels with full cut outs and four panels with debossed prints, as well as a blank panel for you to do whatever you'd like on. Assemble with glue. Battery powered lamps work well.

Might need minimal support for the top part's channels, but if you're confident in your printer's bridges you might be able to get away with nothing.

Cura is 100% going to whine about water tightness. The meshes are all fine as far as I can see, and Cura, in its infinite wisdom, refuses to show where the problem lay in its xray view. As far as I can tell, all the normals are facing the right way and there are no holes in the mesh, and the slice preview looks fine.