Thingiverse
Halloween Spider
von DragonFerocity
44
Downloads
44
Likes
0
Makes
A simple spider, perfect for hanging in a web this halloween!
I used OpenSCad to model this, and the scad file is included if you wish to customize at all.
You can print this all in one go if you'd like. Or, if your printer is capable of printing TPU, you can insert a filament change command at Layer 100 (and a ChangeAtZ command in Cura to adjust the print settings since TPU is more difficult to print).
Using TPU on the tops of the leg joints allow the legs to bend slightly while still being stiff.
Just be careful though since TPU and PLA don't always bond super well to each other!
I used OpenSCad to model this, and the scad file is included if you wish to customize at all.
You can print this all in one go if you'd like. Or, if your printer is capable of printing TPU, you can insert a filament change command at Layer 100 (and a ChangeAtZ command in Cura to adjust the print settings since TPU is more difficult to print).
Using TPU on the tops of the leg joints allow the legs to bend slightly while still being stiff.
Just be careful though since TPU and PLA don't always bond super well to each other!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
