Halo Dice Tower Valhalla Base

UPDATE: I tried putting some smaller dice through it and it worked better, so if you have average or above average sized dice consider scaling it up a bit


Note: I do not recommend using or printing this model, but it's a bit better than the previous iteration and I put a couple hours into trying to make it easier to print, so here's what I've got.

FixedFixedFixed is the file I printed. I would consider it easiest to support, however I would still recommend running the manual supports (I used a Cura custom supports plugin).

Tower plane cut is just that, the tower that has been plane cut to remove a lot of unnecessary features. I struggled with meshmixer and other programs for a while trying to close the bottom of this (removing the lower floor of the Valhalla tower because I didn't want it) and in the end just freehanded a box in Fusion 360 to close up the bottom. Any faceting or similar in the "fixed" model is caused by the process of combining in Meshmixer. If someone else