Thingiverse
Halo Face Shield
von Huat_Prints
16
Downloads
3
Likes
0
Makes
Inspired by the 3DVerkstan face shield, but with added stability due to the F1 halo inspired nose bridge. Can still be worn over glasses comfortably.
Prints in one piece with no supports within 1hr on my prusa mk3. Prints best in PETG, it can be printed in PLA, but the fit might be a bit tight as it would be more rigid.
Face shield width is standard A4 size. Use the PDF face shield template and a hole puncher to punch the mounting slots, pegs are spaced 20mm apart. Use a sharp scissors to cut the corners.
You can use the Prusa Face Shield bottom reinforcement for more curvature support:
https://www.prusaprinters.org/prints/25857-prusa-face-shield
Any feedback is greatly appreciated!
Prints in one piece with no supports within 1hr on my prusa mk3. Prints best in PETG, it can be printed in PLA, but the fit might be a bit tight as it would be more rigid.
Face shield width is standard A4 size. Use the PDF face shield template and a hole puncher to punch the mounting slots, pegs are spaced 20mm apart. Use a sharp scissors to cut the corners.
You can use the Prusa Face Shield bottom reinforcement for more curvature support:
https://www.prusaprinters.org/prints/25857-prusa-face-shield
Any feedback is greatly appreciated!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
