Thingiverse
Electronics
Zum Modell
HAM Logo emblem
152
Downloads
113
Likes
5
Makes
This is a HAM logo model.
Update: Made a model with coil thickness 1.2 mm instead of 0.8 mm. Both models are included.
I printed it with PLA plastic, extruder temp - 200 deg C, bed temp - 65 deg C, 0.1 mm for layer. I used several supports, but coil loops without support also printed well. Raft is on your decision, maybe it is not needed due to big surface.
Update: Made a model with coil thickness 1.2 mm instead of 0.8 mm. Both models are included.
I printed it with PLA plastic, extruder temp - 200 deg C, bed temp - 65 deg C, 0.1 mm for layer. I used several supports, but coil loops without support also printed well. Raft is on your decision, maybe it is not needed due to big surface.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
