Thingiverse
Hammer head
von siderits
15
Downloads
17
Likes
0
Makes
This old hammer lost one of its striking surfaces.
This project prints a mold and stem base for a silicone rubber replacement.
I used an RTV silicone rubber (Tinsil 70-60 Polytek) to pour the replacement hammer head.
http://www.polytek.com/index.php?dispatch=categories.view&category_id=228
This is a high tensile strength, dense rubber.
The mold is about 25 ml in volume.
Designed in trueSapce and printed on an Up!3D in ABS from Octave.
This project prints a mold and stem base for a silicone rubber replacement.
I used an RTV silicone rubber (Tinsil 70-60 Polytek) to pour the replacement hammer head.
http://www.polytek.com/index.php?dispatch=categories.view&category_id=228
This is a high tensile strength, dense rubber.
The mold is about 25 ml in volume.
Designed in trueSapce and printed on an Up!3D in ABS from Octave.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
