Back
Hammock Threader – 3D printable model from MakerWorld MakerWorld
Other Tools

Hammock Threader

by goat
1 Downloads
4 Likes
1 Makes
Download Model
I took the straps off of the ends of my hammocks but I found it hard to get them back in, so I designed this so that it would be easier to put the straps through. It has a part for the long, thin straps and 2 spots for round rope-like straps. You put the strap in the correct spot, then thread it through the long hole at the end of the hammock.
Category
Other Tools
Source
MakerWorld
Published
14.07.2024
Updated
30.01.2026
Comments
0

Comments

No comments yet – be the first!
More Other Tools Models All MakerWorld Models More by goat

Similar Models

6 Suggestions

Add to Collection