Thingiverse
Hand hat holder
door TurtlewithaTopHat
1
Downloads
1
Likes
0
Makes
When you open the STL the hand is super small but when I scaled it to an appropriate size the hole for the screw or nail didn't match the screw I had. The specific screw I was using had the diameter of 8 mm(just the top part) and it would only fit if I scaled it to 3000 or something but at that point the hand was too large. So I used Tinker Cad to change the hole for the screw and it looks good.
I wanted to use a sturdy screw and the screw I used, "I think" it's a pretty common screw that many people will have laying around. I didn't use a drywall anchor just put it right on the wall and it worked good.
Oh the print is called 1300 hand because it is scaled 1300% from the original
I wanted to use a sturdy screw and the screw I used, "I think" it's a pretty common screw that many people will have laying around. I didn't use a drywall anchor just put it right on the wall and it worked good.
Oh the print is called 1300 hand because it is scaled 1300% from the original
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
