Handlebars Key Ignition switch pod

Made for 22mm handlebars.2 Variations. For one of them you need to remove the grip while you dont have for the other. Requires M4x20 bolt and nut. DO NOT PRINT straight up because top layers will separate on the rim !!! You must print at an angle for strength. Requires key ignition switch - this is just a pod to fit itGreat for motorcycles, ebikes, electric scooters and more.Opening in the back is big enough to fit a 4 wire switch aiming down or straight out. You can use these key ignition switcheshttps://amzn.to/450t4ie - 4 wire versionhttps://amzn.to/4qLKU0R - 2 wire version