Thingiverse
Handy Raspberry Pi and breadboard holder
von myastremsky
2
Downloads
0
Likes
0
Makes
The handy holder for holding a Raspberry Pi 2/3/4 and a small breadboard. Also fits for Raspberry Pi Zero (W).
The Raspberry Pi mounting hole sizes (in model) are 3.3mm, which with my printer results in 3.1mm, and would be a perfect fit for M2.5*6*3.5 threaded inserts for recommended M2.5 screws. No drilling of the Raspberry Pi board needed.
A breadboard can be stuck to the holder with its adhesive pad.
For a Raspberry Pi Zero, only 2 screws can be used, or 4 for better stability.
The option **with_finger_cut** will help you to press out the breadboard if you want maybe to change it or disassemble.
The Raspberry Pi mounting hole sizes (in model) are 3.3mm, which with my printer results in 3.1mm, and would be a perfect fit for M2.5*6*3.5 threaded inserts for recommended M2.5 screws. No drilling of the Raspberry Pi board needed.
A breadboard can be stuck to the holder with its adhesive pad.
For a Raspberry Pi Zero, only 2 screws can be used, or 4 for better stability.
The option **with_finger_cut** will help you to press out the breadboard if you want maybe to change it or disassemble.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
