Thingiverse
Hanger
von andsport
11
Downloads
12
Likes
1
Makes
Hi everybody!
This is the coat hanger I've designed to keep my coats.
I suggest a 0% infill: it is sufficient even with 1 or 2 perimeters.
It obviously depends on the loads. Usual PLA is recommended in stead of PET-G for rigidity issues.
I attached these items on doors and on the tiled walls with a bit of hot-glue (spread it around the perimeter and a bit above the center of the bottom).
This design surprised me: it is very strong, well beyond the appearence ;)
Let me know what you think!
Andrew
This is the coat hanger I've designed to keep my coats.
I suggest a 0% infill: it is sufficient even with 1 or 2 perimeters.
It obviously depends on the loads. Usual PLA is recommended in stead of PET-G for rigidity issues.
I attached these items on doors and on the tiled walls with a bit of hot-glue (spread it around the perimeter and a bit above the center of the bottom).
This design surprised me: it is very strong, well beyond the appearence ;)
Let me know what you think!
Andrew
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
