Thingiverse
Hanging Plant Support
por doctorray
2
Descargas
2
Likes
0
Makes
Two piece support to turn a medium planter into a hanging pot.
Bottom support is about 5 1/2" diameter for a 1/4" rope to easily fit in an X shape on the bottom of the planter.
The ring is an 11" inner diameter section with 3/8" holes. It should scale up or down okay to match the upper section of the planter. With the knots, as shown in the picture, it is there to mainly be a guide for the ropes.
The ring is made from 4 identical pieces with a tongue/groove setup. I used epoxy to glue them together into a circle. I was able to print all four at the same time in a smiling "banana" form, used trees as supports on the build plate.
Bottom support is about 5 1/2" diameter for a 1/4" rope to easily fit in an X shape on the bottom of the planter.
The ring is an 11" inner diameter section with 3/8" holes. It should scale up or down okay to match the upper section of the planter. With the knots, as shown in the picture, it is there to mainly be a guide for the ropes.
The ring is made from 4 identical pieces with a tongue/groove setup. I used epoxy to glue them together into a circle. I was able to print all four at the same time in a smiling "banana" form, used trees as supports on the build plate.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!