Thingiverse
Hanging Planter Set
21
Downloads
65
Likes
0
Makes
I designed this small modular vertical planter after seeing something similar in a local greenhouse and wanting to create my own version for 3D printing.
To hang it, I used waxed thread and tied simple knots every 15 cm to keep each planter spaced out (though you can adjust that however you like depending on your setup).
It prints easily with no supports needed. If you’re planning to hang it somewhere with a lot of sun, I recommend using PETG or ABS so it holds up better in the heat.
To hang it, I used waxed thread and tied simple knots every 15 cm to keep each planter spaced out (though you can adjust that however you like depending on your setup).
It prints easily with no supports needed. If you’re planning to hang it somewhere with a lot of sun, I recommend using PETG or ABS so it holds up better in the heat.
ScorpionSensual also publishes on
4 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
