Thingiverse
Hanging Planters
door MakerMind
158
Downloads
168
Likes
1
Makes
These Hanging Planters are quite simple to build and work extremely well.
Apart from the 3D prints, you'll only need some rope with a diameter of roughly 2mm
If you print them in white PLA you can sand them to make them more smooth.
The water bucket will slowly leak water so you will need to put silicone on the inside walls or something like a plastic bag. Preferably just put a normal plant below the whole setup that catches the excess water.
https://www.youtube.com/watch?v=wZPI4dZkh24&feature=youtu.be&ab_channel=MakerMind
Apart from the 3D prints, you'll only need some rope with a diameter of roughly 2mm
If you print them in white PLA you can sand them to make them more smooth.
The water bucket will slowly leak water so you will need to put silicone on the inside walls or something like a plastic bag. Preferably just put a normal plant below the whole setup that catches the excess water.
https://www.youtube.com/watch?v=wZPI4dZkh24&feature=youtu.be&ab_channel=MakerMind
MakerMind publiceert ook op
18 extra modellen op 3 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
