Hanging RepRap Filament Spool Holder

Designed to hang above your 3D printer, 608 bearings allow the spool to effortlessly feed your extruder; hanging by a line allows the filament to twist as it unwinds. I may insert a ball bearing swivel snap (fishing vitamin), but I don't think the spool wants to keep spinning.

Based on my RepRap Spool Holder, highly adjustable for different spools. You may need to adjust the balance point at the hanger as you consume the mass of your filament.

___
**ATTENTION**
This work is licensed under the [Creative Commons - Attribution - Non-Commercial license](http://creativecommons.org/licenses/by-nc/3.0/). This license applies only to the files and documents available for download from the **Thing Files** section of this Thing.
**All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license. with all rights reserved, unless specifically available for download** This notice constitutes a clarifi