Hanging Waste Bin

by BubsBuilds · 3D Printer Accessories

25 Downloads

8 Likes

2 Makes

Designed for use on my i3 printer standA simple waste bin that hangs from 2020 extrusion, intended as a convenient spot for tossing purge lines, brims, and the other assorted scraps/trash that accompany extrusion printing.Prints without supports and took about 3.5 hours with the attached slicer config (0.6 nozzle), but I should point out that the lettering on my print came outa little lackluster.More of my assorted designs for 2020 aluminum extrusionsCategory: 3D Printer Accessories

printer accessory wastebin waste clean trash thingiverse

BubsBuilds also publishes on

215 additional models across 3 more platforms

Printables

108 models

♥ 2,541 ↓ 10,449 ⚒ 79

Frequently Asked Questions

Does Hanging Waste Bin need supports when printing?

No supports needed for Hanging Waste Bin — it's designed to print clean off the bed.

How long does it take to print Hanging Waste Bin?

According to the design notes, Hanging Waste Bin takes approximately 3.5 hours to print at standard settings (0.2 mm layer height, 15% infill). Actual print time varies based on your printer speed, layer height, and infill density.

What file format is Hanging Waste Bin available in?

Hanging Waste Bin is available in STL format. These files can be opened and sliced using free software such as Cura, PrusaSlicer, Bambu Studio, or OrcaSlicer for FDM printing, or ChiTuBox and Lychee Slicer for resin printing. The download is provided through MakerWorld.

Is Hanging Waste Bin free to download?

Yes, Hanging Waste Bin is available as a free download through MakerWorld. Always check the license on the original platform to understand commercial use, remixing, and attribution requirements.

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Hanging Waste Bin

Similar Models

Add to Collection