Thingiverse
Happymodel 1S Charger Shell
door Voyajer
5
Downloads
9
Likes
0
Makes
Update: I have moved to prusaprinters at
https://www.prusaprinters.org/social/215089-voyajer !
Any updated and new designs will be only uploaded there.
Two piece shell for the usb Li-Hv lipo charger that comes with the Happymodel Mobula6. It has holes for the charging status lights (center for Li-Hv, end for normal Lipo batteries).
This model requires gluing on the chamfered edges and optionally recommends a dab of glue on the underside of the PCB.
You may need to clip the pins on the connectors if they protrude further than 1 mm from the bottom of the PCB.
https://www.prusaprinters.org/social/215089-voyajer !
Any updated and new designs will be only uploaded there.
Two piece shell for the usb Li-Hv lipo charger that comes with the Happymodel Mobula6. It has holes for the charging status lights (center for Li-Hv, end for normal Lipo batteries).
This model requires gluing on the chamfered edges and optionally recommends a dab of glue on the underside of the PCB.
You may need to clip the pins on the connectors if they protrude further than 1 mm from the bottom of the PCB.
Voyajer publiceert ook op
19 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
