Thingiverse
Fashion
Go to Model
Hard Case for Airtag
252
Downloads
169
Likes
1
Makes
A simple case for a single Apple Airtag, with an opening at the top for a keychain or other loop. Held together by four M3 screws, which thread into the plastic on the bottom piece itself. Anything longer than an M3x8 will stick out in the back, which is not ideal.
Be sure to print with the outward facing sides down on the build platform.
Four M3x8 screws are required.
Be sure to print with the outward facing sides down on the build platform.
Four M3x8 screws are required.
tonyb486 also publishes on
4 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
