Cults3D
Home
Go to Model
Hard Coffee Coasters
2
Downloads
1
Likes
0
Makes
Check out these clean, two-tone coffee coasters I whipped up! They look sharp and are super easy to print.
I ran these on the K1 Max using the CFS kit for automatic swaps, but the design is simple enough that you can get the same look on a standard printer—just pause and swap the filament midway. It’s a quick, high-contrast project that adds a nice modern touch to any table.
I’m releasing these for free, but if you’d like to show some support, a follow over on my YouTube channel would mean a lot!
https://www.youtube.com/@Kalbo64
I ran these on the K1 Max using the CFS kit for automatic swaps, but the design is simple enough that you can get the same look on a standard printer—just pause and swap the filament midway. It’s a quick, high-contrast project that adds a nice modern touch to any table.
I’m releasing these for free, but if you’d like to show some support, a follow over on my YouTube channel would mean a lot!
https://www.youtube.com/@Kalbo64
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
