Hardware-less/Snap-in M-lok Cable Managers

by WarrenFab · Other Hobby & DIY

900 Downloads

422 Likes

563 Makes

I wanted to not have to worry about finding m-lok hardware for each and every one of these I needed, so this is a solution to that. As of right now, I can only get the horizontal ones to print correctly (without breaking the tabs, not staying in tight, etc), but I also have a vertical mounting model that I may upload at some point for you guys to test. I print them without a brim, but you may find that you need one. I know it sucks you can't print face side on bed plate, but that would severely hurt the strength of them. I can't pry them off by hand, but I can with a tool. Hopefully some of you find this useful!