Thingiverse
Hartmann Handsender Sleeve
von wolllis
3
Downloads
3
Likes
1
Makes
This is a sleeve for the **Hartmann Remote Control** series **HSE 4**.
I designed it for the **HSE 4 BS** but it will most likely also fit for **HSE 1, HSE 2 & HSE 5**.
It will prevent damage to the frame caused by a flawed mechanical design. This will crack the shell after about a year of usage.
The model was designed with **0,5mm tolerance** so everyone with a halfway decent printer should be able to print it. I **simply added paper strips** until it was a perfect fit.
I designed it for the **HSE 4 BS** but it will most likely also fit for **HSE 1, HSE 2 & HSE 5**.
It will prevent damage to the frame caused by a flawed mechanical design. This will crack the shell after about a year of usage.
The model was designed with **0,5mm tolerance** so everyone with a halfway decent printer should be able to print it. I **simply added paper strips** until it was a perfect fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
