HasLab Ghostbusters Ghost Trap - Bar Graph LED Divider

Two in the box, ready to go!

This part will fit under the HasLab Ghost Trap's bar graph diffuser to help separate the individual LEDs and reduce bleed through of adjacent LEDs in the diffuser.

To install, remove the 4 screws securing the bar graph's bezel. Remove the bezel. Lift the diffuser lens and install this part in the opening over the 10 LEDs. Make sure the part it is inserted correctly as the part and opening are at a slight angle. The part should fit tightly in the opening around each LED and allow the diffuser to sit flush in its original position. Reassemble. The effect is most noticeable in the sweeping animation (single LED going back and forth) and the alternating animation.

Only takes 5 minutes to print. I recommend silver or black PLA. Only takes a few minutes to install.