Thingiverse
Hayward Chlorinator Handle
von Jsschlat
36
Downloads
27
Likes
0
Makes
This wrench fits many Hayward CL200, CL220 and other chlorinators with the 6 "knobs" on top. Note that this is a SMALL chlorinator. If you are looking for a wrench for the larger Hayward chlorinators, dankvwguy has done a remix that should work.
After several years of age, my chlorinator required me to use a very big pair of channel locks to tighten the top on enough to maintain a seal and prevent leaking. Even a new gasket didn't help. I got tired of bringing out the channel locks every time I needed to add chlorine so I created this wrench.
The fit is intentionally a bit loose to make it easy to get the wrench on and off.
I used PLA+ for the material with 40% infill. After several uses, I haven't had any problems with strength or deformation of the wrench.
You can also buy these for about $25 on Amazon, but I preferred to design and make my one for ~$0.69 :)
After several years of age, my chlorinator required me to use a very big pair of channel locks to tighten the top on enough to maintain a seal and prevent leaking. Even a new gasket didn't help. I got tired of bringing out the channel locks every time I needed to add chlorine so I created this wrench.
The fit is intentionally a bit loose to make it easy to get the wrench on and off.
I used PLA+ for the material with 40% infill. After several uses, I haven't had any problems with strength or deformation of the wrench.
You can also buy these for about $25 on Amazon, but I preferred to design and make my one for ~$0.69 :)
Jsschlat veröffentlicht auch auf
13 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
