HB1 Motor Mount Enhanced

I modified the motor mount to have slightly smaller screw holes where it attaches to the fuselage and I added extended pieces, so the screws have more material to grab on to. The original motor mount had some play that caused the thrust angle to change. It's now rock solid with this modification.

No supports needed.

I printed mine with PETG at 0.2mm layer height and 40% cubic infill.

I used self tapping M3 screws to attach to the fuselage.

###Want to support my work for free?
**Check out [Amazon](https://amzn.to/3ZOvYVI) for your hobby supplies**
(as an affiliate, I earn a small commission if you buy from Amazon, but there is no extra cost to you)