Thingiverse
hbx devastator body
door Jedi_Craig
70
Downloads
55
Likes
2
Makes
new shell for RC crawler HBX devastator. Print pieces separate and acetone weld them together or glue or epoxy. blower motor print 1.9X size.. the model file is too small. I put the alignment tool under hood and motor slot. aligns the side panels to hood while you glue it and acts as a base for the motor.
can go right over existing body posts. I put pins in back posts below and above body, holds nicely, didnt need to pin the front.
can go right over existing body posts. I put pins in back posts below and above body, holds nicely, didnt need to pin the front.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
