Thingiverse
HD Y Motor Mount
von Sndgjaytr
67
Downloads
38
Likes
0
Makes
VERSION 2 available to download.
https://www.thingiverse.com/thing:3747929
This is a remixed of a Y Axis Dual Damper Mount For CR-10/CR-10S (by mce076). ALL credits to original creator. Much appreciated. I just remix for my FLsun.
This heavy duty mounting bracket can support 60mm motor for high torque.
This bracket was intended to use with this heavy duty Y Belt Tensioner that I remixed but can be use separately if the height of the belt is ~20mm.
https://www.thingiverse.com/thing:3157199 Y Belt Tensioner (up to 10mm dia.)
You should double check your bed clearances and also the height of your belt before you print.
Update:
======
[6/4/19] This Y motor mount now includes a rear mount for noise damper. OPTIONAL. I didn't have the 4 long bolts that people say you should use to fasten the damper to the motor... so I used super glue with instant cure and it worked just fine. Been 4 months and it's still going. =) I don't think people give super glue enough
https://www.thingiverse.com/thing:3747929
This is a remixed of a Y Axis Dual Damper Mount For CR-10/CR-10S (by mce076). ALL credits to original creator. Much appreciated. I just remix for my FLsun.
This heavy duty mounting bracket can support 60mm motor for high torque.
This bracket was intended to use with this heavy duty Y Belt Tensioner that I remixed but can be use separately if the height of the belt is ~20mm.
https://www.thingiverse.com/thing:3157199 Y Belt Tensioner (up to 10mm dia.)
You should double check your bed clearances and also the height of your belt before you print.
Update:
======
[6/4/19] This Y motor mount now includes a rear mount for noise damper. OPTIONAL. I didn't have the 4 long bolts that people say you should use to fasten the damper to the motor... so I used super glue with instant cure and it worked just fine. Been 4 months and it's still going. =) I don't think people give super glue enough
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
