HDD case

Enclosure for a 2.5" HDD, this one is from an old MacBook. The enclosure prints in two parts, I used some M3 heat insert nuts on the base and 4 M3 6mm bolts to hold it all together. I also tapped the lid holes after printing, this isn't necessary but helps with stability. I left a little space on the inside of the lid for a bit of protective padding, I used 2mm EVA craft foam but again this isn't necessary. Please feel free to remix.

M3 Heat inserts
https://a.co/d/8dCrRHZ

M3 Bolts
https://a.co/d/cDXICo4

SATA to USB C Cable
https://a.co/d/bzg6sLG