Thingiverse
HDPE 32mm drilling guide
von kpr
1
Downloads
0
Likes
0
Makes
This is simple tool for drilling 22mm hole into HDPE 32mm tubes.
HDPE tubes are usually used in water distribution in house, or in gardens. For creating watering branches, I use Gardena 2729-20 side connector (belt style), which should be hole-drilled on HDPE 32mm.
For creating hole I use circulat cutter (hole saw)l, i.e. from Wolfcraft p/n 5463000, that is guided well with this tool.
HDPE tubes are usually used in water distribution in house, or in gardens. For creating watering branches, I use Gardena 2729-20 side connector (belt style), which should be hole-drilled on HDPE 32mm.
For creating hole I use circulat cutter (hole saw)l, i.e. from Wolfcraft p/n 5463000, that is guided well with this tool.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
